The EAA website is currently undergoing maintenance. Portions of the website, including membership login, join, renewal, shopping, and AirVenture ticketing may be unavailable at that time. We apologize for any inconvenience.
Found in the Field
By Vic Syracuse, EAA 180848, Technical Counselor/Flight Advisor
Recently I inspected an aircraft that had the oil filter safety wired to the firewall. That was definitely a no-go as there was movement between the firewall and the engine. In fact, in this particular case it was safety wired such that the movement would have loosened the oil filter. Safety wire should always be used between the object being safetied and another location on the same piece that is fixed.
Here’s a picture of the vertical fin forward attach point on an RV-7 that had been flying for seven years. Clearly, the rivets are not set properly. A good rule of thumb is that the rivet should be approximately half the diameter in height and 1-1/2 times the diameter in width once it is set. In this case, these can easily be rectified in a few minutes with a rivet gun and a bucking bar. They should have been caught during the airworthiness inspection and for sure on the subsequent condition inspections.
In the really poor riveting category, here is a picture of the rear spar on an RV viewed from the inside. The rivets are holding the aileron bracket to the spar, clearly a high-stress area. In fact, Van’s Aircraft has issued a service bulletin requiring inspection of this area prior to further flight. In this case, the condition inspection was signed off three months after the service bulletin was published.
Airplanes typically have hoses to deliver fuel and oil to the engine. Many of the hoses have a useful life to them. At the very least, airplanes that have sat for a long time, especially those that sit outside in a harsh environment, should be thoroughly checked prior to flight. In this case, the airplane had sat outside for almost a year in a hot and humid environment. While engine run-up was seemingly done without any problems, a thorough prebuy inspection discovered this crack in the inlet hose to the fuel pump. A potential loss of power during takeoff was prevented.
Ever wonder why the heater doesn’t seem to be working? Here’s an example of SCAT tubing that was installed with a very sharp bend in it. Eventually it failed and collapsed, preventing the flow of air to the heat muff and depriving the cabin of hot air.